Without PPA

Polymer processing aids (PPA) are fluoropolymers based additives used to increase productivit and quality during extrusion of PE products (films, profiles) without compromise on performances as only few hundred ppm are needed. Also, PPA can offer a clear improvement when fractional melt index PE grades are pelletized. When using those additives, the granules will have a much smoother surface as the melt fracture that sometimes appears at high production rates will be significantly reduced.

Daikin, has developed a more efficient PPA (DAI-EL™ PPA), based on a new fluoro-elastomer 
chemistry. Thanks to its higher efficiency, similar level of performances can now be achieved at lower concentrations (up to 50% lower than a traditional PPA) - without compromising on gels formation and die build up.
These benefits are especially appreciated in highly demanding lamination and surface protection

application.

Reduces PPA additives cost as lower PPA additive concentrations are needed (up to 50% less)

Is suitable for highly demanding blown film applications such as lamination and surface protection

Control your logistic cost during transportation thanks to higher bulk density (smooth surface on the pellets)

 

Blown film & cast film products Food and non-food packaging film Agricultural film Tapes	Wire and cable insulation / jacketing: Telecommunication Low voltage
Extrusion blow molding: Bottles Drums Tanks	Pipes & tubing: Water and gas high pressure pipe Sewer and drainage pipe Irrigation tubing Conduits
Extruded fibers: Mono-filament for bailing twine, agricultural net sacks, fishing nets and ropes Multifilament

More Details